John H.


I found the youtube videos and they ran much smoother. The gun is assembled now. I have to find where I put helo-sight I’ve been saving for this project since Xmas last, do a bit of bore sighting, and I’m off to the range.

I had to file the wood on the front of the hand guard, but also do a bit of relieving at the back end. The two round bumps on the part that used to hold the rear sight on my Yugo, had about 1/16″ interference with the hand guard plastic on either side. A little work with the dremel drum sander fixed that.

In the instructions you did not say anything about the original Yugo safety. I puzzled on this then decided to leave it on, and everything worked out OK.
I hope you find these comments useful.


(New Mexico)


Comments are closed.